Glue

Glue for different types of applications.
Sort By:  
GS Hypo Cement (COL001)
Transparent glue from the USA for the jewellery, watchmaking and model making industries.

For: plastic, glass, metal, stones, pearls, ceramics, watch glasses, silk knot necklace

Thanks to the 0.7mm micro needle with a 0.3mm hole!!! even for the smallest parts.

Dries clean, leaves no marks, does not stick to fingers and does not destroy surfaces.

Drying time of approximately 10 min.
6.70€
Glue UHU Plus Endfest 300 (COL005)
Two-component, solvent-free, epoxy resin-based glue for the highest loads.
Processing time is up to 120 minutes.
Hardening time and final strength (up to 3000N/cm2) depend on temperature.
Solid after 12 hours at room temperature.
The adhesive connection is impact, aging and moisture resistant.


Materials:
Glues metals, glass, porcelain, ceramics, wood, marble, stone, concrete, duroplastics, fiberglass reinforced plastics, rigid PVC, rubber, rigid foam plastics, e.g. Polystyrene.
Not suitable for bonding large glass, PE, PP surfaces.


Instructions for use:
  • Adhesive surfaces must be dry and free of dust and grease.
  • Render smooth surfaces.
  • Mix the binder and hardener in a 1:1 ratio (equal length strands).
  • Apply the adhesive on one side, on rough materials on both sides.
  • Assemble the parts correctly without pressing.
  • Processing time (lifetime): approx. 120 minutes.
  • The hardening time and the final strength depend on the temperature, at room temperature it is adjusted after approx. 12 to 24 hours.

Pack Content: 33g
14.30€
UHU Plus Fast Glue (COL006)
Two-component, solvent-free epoxy resin adhesive for fast, resilient bonding.
Allows high strength adhesive connections to almost all solid materials. Processing time is up to 5 minutes, hand strength is reached after 20 minutes. The final strength is approx. 1300 N/cm².
The adhesive bond hardens transparently, is impact, aging and moisture resistant.

Materials:
Glues metals, glass, porcelain, ceramics, wood, marble, stone, concrete, thermosetting, fiberglass reinforced plastics, hard PVC, rubber, hard foam plastics, e.g. Styropor®.

Not suitable for bonding large glass, PE, PP surfaces.

Processing / Instructions for Use
Adhesive surfaces must be dry and free of dust and grease. Render smooth surfaces. Mix the binder and hardener in a 1:1 ratio (equal length strands). Apply the adhesive on one side, on rough materials on both sides.
Assemble the parts correctly without pressing. Processing time (lifetime): approx. 5 minutes.

Hardening time: solid
after approx. 20 to 30 minutes at room temperature

Content: 35 g
15.80€
Per Page      1 - 3 of 3
  • 1